51mm Metal Deck Roll Forming Machine 0.8-1.2mm Galvanized Steel

51mm Composite Slab With Metal Deck Roll Forming Machine Structural

The thickness of the floor slab mainly depends on the thickness of the floor slab (concrete) and the spacing of the secondary beam, this calculation has a technical content, it is based on the section modulus of the floor slab, the section moment of inertia and other relevant data calculated. Here, a brief description of the basis of judgement in normal circumstances is given. (metal deck roll forming machine/metal deck bending machine)

Under normal circumstances, the span between the steel beam within 2m floor plate thickness in 0.75-0.8mm on it; 2-2.5m floor plate thickness with 0.8-1.0 on it; span in 3-4m floor plate thickness with 1.5mm, more than 5m span is finally with temporary support. (floor decking roll forming machine/ floor decking bending machine)

Of course, the above is only from the plate thickness perspective, without taking into full consideration the plate type, strength and other factors. There is also a factor that we can easily ignore is the good or bad of the screw is also to determine the thickness of the floor bearing plate, the better the screw the stronger the bearing capacity of the floor bearing plate. (Steel deck roll forming machine/Steel deck bending machine) (roof deck roll forming machine/ roof deck bending machine)

Flow chart of 51mm Composite Slab With Metal Deck Roll Forming Machine Structural:

Hydraulic decoiler--Guiding--Embossing--Roll forming--Hydraulic cut--Out table

51mm Composite Slab With Metal Deck Roll Forming Machine Structural Parameters:

Pictures of 51mm Composite Slab With Metal Deck Roll Forming Machine Structural:

51mm Metal Deck Roll Forming Machine

1.2mm Metal Deck Roll Forming Machine

0.8mm roll forming equipment

51mm Metal Deck Roll Forming Machine 0.8-1.2mm Galvanized Steel Images